If your sensor board needs to be in an offset position you will need to tell the system how much the board is off set and which direction it is off set.

The file you need to edit is here: C:\TruGolf\E6 Golf 1.6\TruTrack.xml

• Under the <Booth> section at the top of the Xml you will need to change the <Center_Offset Value=“0.00”/>. This will tell the system how many the offset needs to be.

Note: This variable is in feet 18” =1.50 24” = 2.00

• Next you will need to change the <Analyzer_Mode Value=“0”/> located at the bottom of the <Trutrack specific> portion of the Xml.

This variable will tell the system which direction the board is offset. “0” = Center “1” = Right only “2” = Left only “3” = Dual