Club camera light won't turn on for the TruFlight 2

Club camera light won't turn on for the TruFlight 2

The light used for the Truflight 2 club camera isn’t turning on or lighting up.

  • Verify that the 2 Pin Molex cable from the club camera is securly connected to the power plug for the 2 Pin Molex cable. To do this you will want to press inward towards the connector on both ends by holding onto the wires.

Note:
The 6’ USB 3.0 Extension and 2 Pin Molex cable should be run from the Ball camera Enclosure to the Club Head Camera Enclosure

• USB 3.0 Cable will plug into the Club Head Camera

• To plug in the 2 Pin Molex cable, remove the endcap of the enclosure and slide out the lighting cover 3” to reveal the power plug for the 2 Pin Molex cable.

• Insert the 2 Pin Molex power cable through the hole on endcap facing the impact screen.

• Insert the 2 Pin Molex power cable into the power plug

  • Verify that there is power to the club camera light by using a volt meter. If you are using a a volt meter that requires a manual max voltage setting but sure that it is set to 200v so that the voltage can be read.