How to install/mount APOGEE (Resellers/Self Installer)

How to install/mount APOGEE (Resellers/Self Installer)

Issues:
How do I mount the Apogee unit?
FAQ’S (See attached PDF)

Resolution:
The Apogee Manual covers how the mounting of the unit is to be done.
Most of the installation process should be covered with their sales person they are given documentation that includes the manual and  an FAQ manual that covers many questions (this not on our website yet) such as Lighting, turf and other items. 
The Apogee must be installed between 9’-10’ on a flat level surface and any thing out this out of spec and not supported.
There are 3 key elements that determines how the unit is mounted.
      • Determine the center line of their space (usually this is in the middle of that space)
      • Use the Tee to Apogee Table to determine mounting Height. Measure from your Tee Position back (21”-25”” this will determine the units height). Mark this position on the ceiling this where the mount center bolt will go through our mounting plate.
      • The height is measured to the top of the mounting bracket we provide.


    • Related Articles

    • APOGEE Ball Snap (How to Troubleshoot)

      Issue: The laser stays on even though the ball is in the proper location after the APOGEE has been calibrated. Ball Snap: Is a term to describe the the relationship between the laser disappearing when a ball is placed within the laser target on the ...

    • How to install the PGR Firefly MV FMVU-03MTM drivers for TruFlight 1

      How to install the PGR Firefly MV FMVU-03MTM drivers 1. Copy “C:\Program Files\TruGolf\E6 Golf 1.6\Drivers\TruFlight” into the Windows search bar. 2. Click and run the FlyCapture_2.9.43_x86.msi 3. Click next 4. Check the “Accept” box and then click ...

    • What's in the box? Apogee package includes

      Packaged Items Hardware APOGEE Launch Monitor APOGEE Ceiling Mount Paper APOGEE Calibration Template Use this to complete calibration inside the APOGEE Control Center Software. “Hey APOGEE,” Voice Command Instructions User Guide to the Voice Command ...

    • Apogee 0 Degree Not ready

      Issue: Shots aren't registering, ball is not detected, and error "0 Degree not ready" as shown below: Resolution: The Apogee Tracking system is not selected Note: this could be due to it's a first time install or new device has been installed due ...

    • How to update Apogee Firmware and Intelligent Dashboard

      Issue: Needing to update Apogee firmware and/or Apogee Intelligent Dashboard. This is two step process. You must first check which version is currently installed. Some older unit may be lower than .50 firmware. If so please follow Process 2. NOTE: E6 ...