Configuring the Trutrack.xml in E6Golf 1.6

Configuring the Trutrack.xml in E6Golf 1.6

Configuring the Xml

Setting the booth dimensions

  • If this is a custom built unit, you will want to check all the dimensions of your booth and tracking to confirm the system is calculating correctly. If this set up is for a technique or Vista model use your Xml as the guide line for set up.

Note: The variables listed below my not be set the same as your simulators TruTrack.xml.
(The TruTrack.xml can be found here: C:\TruGolf\E6 Golf 1.6)
Must be opened with Notepad Right click on the XML file and select “Edit” or open with>Notepad

<Booth_Width_Inches Value="132.000000
This is the distance between the left and right microphones and is used as part of the acoustic triangulation. It is important to have this measurement exact for proper calculation.

<Booth_Height_Inches Value=“93.000000”/>
This is the distance between the ground and the top microphone and is used as part of the acoustic triangulation. It is important to have this measurement exact for proper calculation.

<Ball_To_Screen_Inches Value=“115.000000”/>
This is the distance from the hitting screen to the row of sensors closest to the hitting screen. This is used to calculate the time of travel for the ball to hit the screen. It will affect the launch angle, ball speed and the distance of the shot.

<micInchesFromScreen Value=“34.000000”/>
The distance from each microphone to the hitting screen. All microphones should be at equal distance from the screen for a proper calculation of the shot.

<lightHeight Value=“90.000000”/>
The distance the Bottom of the overhead lamp to the ground. This sets the variable for how the system registers what club was being used and the face angle. It will also affect the timing of the shot taken.

<lightDistanceFromRow1 Value=“30.000000”/>
This is the distance that the overhead light is from the row of sensors furthest from the hitting screen. It is measured at ground level directly below the overhead light to the sensors. This sets the variable for how the system registers what club was being used and the face angle. It will also affect the timing of the shot taken.

    • Related Articles

    • Transferring a xml file from one computer to another in E6Golf 1.6

      How to copy an XML file from an existing computer to a new one If you are switching to a new computer and have a custom simulator or settings that have been made to your configuration you might want to copy your preexisting XML file from the original ...

    • Transfer Authorization: in E6 Golf 1.6

      Moving (Transferring) your E6 Golf 1.6 License (Authorization) between computers Symptoms • You recently bought a new computer, and need to move your license/authorization to the new machine • You only have the Wade Hampton Golf Course • You recently ...

    • Side Spin Adjustment in E6Golf 1.6

      How To Change The Side Spin Adjustment MPORTANT – Back up your XML file before you make any changes. In the XML file dedicated to your tracking device you will need to locate the Side Spin value <Percent_SideSpin Value=“100.00”/>: ...

    • How to Connect the Flightscope X3 device in E6Golf 1.6 to Wifi

      To Connect the Flightscope X3 device in E6 Golf 1.6 This is a little complicated, as the X3 came out long after E6 Golf was first introduced. And it’s not fully compatible (see below). Open up FlightScope.xml and change the PreferredDevice from ...

    • How do I setup E6Golf up with the TM4 in E6Golf 1.6

      Step 1: Make sure that E6 1.6 is fully installed on the PC. Download of latest version is available at https://e6golf.com/update/ Step 2: Load the latest version of TM4 firmware, which enables putting capabilities. Update will be available in TPS ...