Booth Configurations settings Defined in E6 Connect

Booth Configurations settings Defined in E6 Connect

E6 Connect Configurations settings Defined
Note: The settings not listed are not required for set up and should only be adjusted by an experienced installer

Ball On Screen Distance – This will tell the system when the send shot if no acoustic option is being activated. This can be used to assist shots from a distance that are not being read due to soft acoustics.

Booth Width This is the distance between the left and right microphones and is used as part of the acoustic triangulation. It is important to have this measurement exact for proper calculation.

Booth Height This is the distance between the ground and the top microphone and is used as part of the acoustic triangulation. It is important to have this measurement exact for proper calculation.

Sensor Row To Screen This is the distance from the hitting screen to the row of sensors closest to the hitting screen. This is used to calculate the time of travel for the ball to hit the screen. It will affect the launch angle, ball speed and the distance of the shot.

Screen To Microphones The distance from each microphone to the hitting screen. All microphones should be at equal distance from the screen for a proper calculation of the shot.

Center Offset This will tell the system how much the sensor board is off center .

AnalyzerMode This variable will tell the system which direction the board is offset. “0” = Center “1” = Right only “2” = Left only “3” = Dual

    • Related Articles

    • E6 CONNECT Mini Map Appearing In Center of Screen

      Symptom: E6 CONNECT map appears in the center of the screen when playing a course (see image). ISSUE is caused by when customer has E6 Connect to open to MONITOR and not PROJECTOR, then by moving the E6 Connect screen to the projector via WINDOWS KEY ...

    • How to Configure Offset in E6 CONNECT

      You want to offset your hitting mat to the right or left 1. Launch the E6 CONNECT software 2. Select the Settings (Blue box at the bottom) 3. Select Simulator in left column 4. Select Projector Dimensions in middle column 5. Select the direction that ...

    • Handicaps in E6 Connect

      How is a Golf Handicap established in E6 Connect? There are two ways to establish a handicap in E6 Connect: Manually enter a handicap number when creating the player profile. (this can only be done once, and cannot be edited) Complete a series of 9- ...

    • No Sound in E6 CONNECT for iOS

      Symptom: E6 CONNECT is not playing any sounds on an iOS Device. There are two things we need to look at: FIRST Make sure your iOS device is not in SILENT MODE iPhones have a switch... Some devices are turned on/off in settings menus SECOND Sounds can ...

    • No Ball on Screen in E6 CONNECT

      SYMPTOMS You do not see the ball on screen This change was added to make putting feel more natural by improving the visualization of distance from your physical ball position to the pin. E6 CONNECT attempts to put the rendered view where your ...