Apogee 0 Degree Not ready

Apogee 0 Degree Not ready

Issue:  Shots aren't registering, ball is not detected, and error "0 Degree not ready" as shown below:





Resolution:
  1. The Apogee Tracking system is not selected
Note: this could be due to it's a first time install or new device has been installed due replacement.

  1. Launch E6Connect
  2. Open Settings
  3. Select Simulator
  4. Click on Tracking System
  5. Select Apogee, then configure, then connect and the device will connect and show up in the list.

  1. No Apogee selected 


  1. Apogee Connected